KeelGuard

The KeelGuard is a very simple product to install; however, the following instructions must be strictly followed. Any short cuts or missed steps will jeopardize and compromise the full bonding capabilities of the 3M adhesive. For best results the KeelGuard should be installed at an ambient temperature of 60º or above.

Typically, the KeelGuard is mounted 4 to 6 inches above the waterline on the bow, ending 2 to 3 feet or more beyond the lowest point of the Keel. If protection is required above the Boweye, a separate Bow Guard is available in 1ft to 3ft lengths. For personal watercraft, begin the KeelGuard approximately 1 inch below the bow hook, running the length of the keel, and ending 4 to 6 inches forward of the pump intake.

Application Kit Included

Note: If your trailer is designed such that the entire weight of the boat rests on rollers or a support beam along the keel, we do not recommend installing the KeelGuard.  If the rollers can be lowered or the side bunks raised to clear the rollers, the KeelGuard adhesive bond will not be compromised.  Application may not be suitable for some aluminum boats with reinforced rib design.  Please contact Megaware KeelGuard for your particular application.